How To Fix A Leaning Floor Lamp

Check out life the wild ride at http lifethewildride c.

How to fix a leaning floor lamp.

You can replace a socket so easily that even if it s not your favorite lamp you may want to fix it and give it to someone else like your nosy neighbor. Table lamps are essentially decorative elements and a light fixture threaded onto a long metal rod with a nut at the bottom to hold the parts in place. If you have a lamp with a loose socket that causes the lamp to flicker to be difficult to turn on or to just flat out refuse to light you can replace the socket and give the lamp a new life. When a floor lamp stops working there are usually two causes for the problem.

Pic of leaning floor lamp pic of lamp unscrewed pic of lamp with duct tape added to the inside pic of straight lamp. Get the new socket the one with. If the lamp is leaning from the base tighten the bolt that is in the base of the lamp. 1 unplug the floor lamp.

Gently lean the lamp downward and rest the top of the floor lamp the area near the bulb down on the pillow. Once you understand the simple construction of a table lamp it is very easy to repair the wobbly lamp. Then in the reverse order tighten each section until you get back to the bottom. At this point unless the lamp pole is bent somewhere the lamp should not be leaning anymore.

The shade may be left in place if it is a solid. You can begin repairing a floor lamp by disassembling the lamp. Once you determine from where the lamp is leaning you can make the necessary steps to fix it. For many people a sagging or leaning floor lamp means it is time to buy a new one.

Run it in the lamp and then through the socket. 2 unscrew the section that is loose. A majority of floor lamps are comprised of threaded pipes joined by screws. Some floor lamps need socket wrenches to tighten the bolt and others have philips screws that need to be tightened.

Yes this is a quick fix and since there are some affordable floor lamps available it can easily be done without worrying about your budget. A bad socket or a bad cord. Get the new wires. Unfortunately many floor lamps tend to lean over time because the pole s grip loosens and sags to one side.

This will eliminate the possibility of replacing one part only to have the problem be the part that was not replaced. If so you will need to basically disassemble the lamp from the bottom up. 3 take a small piece of duct tape and wrap it around the inner grooves of the pole. Do not lose any of the pieces.

Since both of these issues involve taking apart the lamp it is wise to replace both items. With common tools you can fix your wobbly lamp in minutes. 4 reattach pole and screw on until tight.